Running T-Plan Robot with RealVNC Enterprise

Queries related to T-Plan Robot
Post Reply
Site Admin
Site Admin
Posts: 21
Joined: Wed Oct 29, 2003 5:26 pm

Running T-Plan Robot with RealVNC Enterprise

Post by Dave » Fri Oct 29, 2010 3:45 pm

If you are looking to use T-Plan Robot (version 2.2 or higher) in conjunction with RealVNC Enterprise v4.5.4 there are some specific settings that you must configure as detailed below.

On the Connections tab (for the VNC server) change the settings for the values below:
Authentication - None
Encryption - None
Prompt VNC Server user to approve connections - Untick

On the Expert settings tab:
Protocol 3.3 - True

No changes are required to the VNC Viewer end of things with T-Plan Robot.

NB. It has been observed that response times with RealVNC Enterprise 4.5.4 running in this RFB 3.3 compatibility mode appear to be reduced however this has not be objectively tested at this stage. While we do not know precisely how Real have implemented the backwards compatibility in this release it is possible that some protocol translation is going on and that this may create additional overhead.

Our thanks go to Gary for this information.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest